[johnkosir]

The brackets are very easy too make I made 4 for when I did my seal at Bella Terra No cart required too do Valid seals the hardest part is taking the room apart. you can move the room with 1 finger if your bearings are good, the brackets stop the room from falling off the bearings, If some one can tell me how to post pictures I will post a picture off mine and dimensions
bracket I copied         

bracket installed is the picture after the drawing , the white screws have to be removed to let you over extend slide,

[Richard]

John..

Edit your post, when the button asks quick edit or full edit, choose full edit.

Then below the space where you would type, there will be a box that allows you to chose attachments.

Once you have chosen a picture, and allowed it to load. You will see a button on the far right that allows you to insert into the text. Before choosing that button, ensure the cursor is where you want to insert the picture into the text.

[[email protected]]

The brackets are very easy too make I made 4 for when I did my seal at Bella Terra No cart required too do Valid seals the hardest part is taking the room apart. you can move the room with 1 finger if your bearings are good, the brackets stop the room from falling off the bearings, If some one can tell me how to post pictures I will post a picture off mine and dimensions
bracket I copied 

bracket installed is the picture after the drawing , the white screws have to be removed to let you over extend slide,

do you have any more detail regarding finding screws/attachment of slide trim etc. My bedroom drivers side has a leak- Valid slides. brackets attached where?
Thanks
JD

[Fulltiming]

The easiest way to post pictures in a thread is to start your message in the box at the bottom of the page then click on the Preview Post button. That will take you to the full message editor. At the bottom of the Post a New Reply section will be an Attachments section. You can either drag and drop your image(s) or click on the Attachments area and a pop-up window will allow you to locate the file on your computer. After you located the file, click Open and it will upload the photo file(s).

[[email protected]]

do you have any more detail regarding finding screws/attachment of slide trim etc. My bedroom drivers side has a leak- Valid slides. brackets attached where?
Thanks
JD

[johnkosir]

The brackets attach to the slides for the bearings, there is a picture of the brackets attached.  Every Newell is different, The 1st one I did was drivers side bedroom, I have drawer at the front side of the bedroom just had to stick my head in and find the screws and the drawers came out, the other side I had to cut the silicon that was holding the corlan down to remove it then I could reach in and get at the screws, had to remove the bed , frame and headboard, I remember having to look for holes in the vinel to find and remove screws

[hypoxia]

do you have any more detail regarding finding screws/attachment of slide trim etc. My bedroom drivers side has a leak- Valid slides. brackets attached where?
Thanks
JD

Where is the leak?  If at the bottom of the slide seal check THIS THREAD .  It is fairly common for a leak to occur at the ends of the slide seal where it is folded over, glued and then held down with a metal plate.

This thread should be moved to the Valid Slide Section, IMHO.  The HWH guys start thinking they may be affected