Posts: 316
Threads: 41
Joined: Oct 2018
(11-24-2024, 10:05 AM)johnkosir Wrote: Have no light on dash with 0 psi in system, pressure switches seem to fail often has anybody thought about installing it on a minemiss connector you don"t have to reduce pressure to 0 to change it, and you can check to see if it is working just by removing it.
I was going to install a valve prior to the sensor to isolate it if necessary.
Since I have adjusted my RAS system pressure to the ZF recommended values I need to install a pressure sensor with a lower trigger value. I’ll probably use 200-210 psi.
JK
Kristi & Jeff King
Bentonville, Arkansas
#744 2005 45’ Newell Coach
ZF Suspension/Active Steering Tag Axle
CAT-13 ACERT KCB Engine 525HP 1642 ftlbs Torque Cat Compound Turbocharger 43.5 psi
Allison HD4000MH Transmission with PTO drive.
Posts: 493
Threads: 59
Joined: Jun 2022
(11-25-2024, 07:21 AM)jdkskyking Wrote: (11-24-2024, 10:05 AM)Since I have adjusted my RAS system pressure to the ZF recommended values I need to install a pressure sensor with a lower trigger value. I’ll probably use 200-210 psi. Wrote: JK
I adjusted the Noshok 300L to about 170psi. There is a switch function adjustment on the top of the 300L. No particular reason for that pressure, I just got tired of pressurizing, depressurizing & adjusting it and 170 seemed reasonable. I did not adjust hysteresis. I have the DIN electrical plug.
(11-25-2024, 07:21 AM)jdkskyking Wrote: [quote pid="67309" dateline="1732467904"]
I was going to install a valve prior to the sensor to isolate it if necessary.
Since I have adjusted my RAS system pressure to the ZF recommended values I need to install a pressure sensor with a lower trigger value. I’ll probably use 200-210 psi.
JK
[/quote]
(11-25-2024, 07:21 AM)jdkskyking Wrote: [quote pid="67309" dateline="1732467904"]
I was going to install a valve prior to the sensor to isolate it if necessary.
Since I have adjusted my RAS system pressure to the ZF recommended values I need to install a pressure sensor with a lower trigger value. I’ll probably use 200-210 psi.
JK
[/quote]
(11-25-2024, 07:21 AM)jdkskyking Wrote: [quote pid="67309" dateline="1732467904"]
I was going to install a valve prior to the sensor to isolate it if necessary.
Since I have adjusted my RAS system pressure to the ZF recommended values I need to install a pressure sensor with a lower trigger value. I’ll probably use 200-210 psi.
JK
[/quote]
Jim
2014 Newell Coach 1482 Mid Entry 45'8" Valid Slides and Valid Levelling
